Eibach ERS 11.00 in. Length x 5.00 in. OD Conventional Rear Spring
Eibach produces some of the finest conventional rear springs in the world. Other springs may frequently sag or need replaced. Top race teams from F1 to WRC, from Le Mans to NASCAR inevitably turn to Eibach. They produce springs with unparalleled precision and repeatability, using the world's finest Hi-Ten spring steel produced to exceedingly precise tolerances. Eibach uses state-of-the-art technology in every step of the manufacturing process.
Eibach conventional rear springs feature:
* Ultra-lightweight for reduced unsprung mass
* Maximum deflection in combination with smallest block heights
* Exceptional block resistance and durability
* Precision plan-parallel and square end configurations under unloaded and loaded conditions
* Lowest side loads with load center ideally located relative to spring axis
* Precision tolerances--the tightest in the industry
* Highest linearity and guaranteed rate consistency
* Each spring individually tested and rated
SKU | 1100.500.0900 |
---|---|
General Specification | Spring Position: Rear Spring Type: Coil Spring Rate (lbs/in): 900 lbs./in. For Street Use: No Bushings Included: No Coil Spring Height (in): 11.000 in. Coil Spring Diameter (in): 5.000 in. Progressive Rate Spring: No Front Leaf Spring Bushings Included: No Spring Finish: Red powdercoated Quantity: Sold individually. Notes: Block height: 4.960 in., load at block height: 5,435 lbs., and travel is 6.040 in. |
Select a category
Categories
-
- Acura
- Aston Martin
- Audi
- BMW
- Buick
- Cadillac
- Chevrolet
- Chrysler
- Datsun
- Dodge
- Ferrari
- Ford
- GMC
- Honda
- Hyundai
- Infiniti
- Jaguar
- Jeep
- Kia
- Lamborghini
- Land Rover
- Lexus
- Maserati
- Mazda
- Mercedes Benz
- Mini
- Mitsubishi
- Nissan
- Oldsmobile
- Pontiac
- Porsche
- Saab
- Saturn
- Scion
- Smart
- Subaru
- Suzuki
- Toyota
- Volkswagen
- Volvo
- Universal
- Lotus
- Prius
- Tesla
- Dampers
- Fiat
- Gear