Eibach ERS 10.00 in. Length x 1.88 in. ID Coil-Over Spring

CA$77.26
 
SKU: 1000.188.0090
Current Inventory: Special Order, ships withing 10 to 15 business days.

Eibach coilover springs are some of the finest race car springs in the world. When other springs sag, or need frequent replacement, top race teams from F1 to WRC, from Le Mans to NASCAR, inevitably turn to Eibach.

To produce springs with unparalleled precision and repeatability, Eibach uses the world's finest Hi-Ten spring steel, produced to exceedingly precise tolerances. State-of-the-art technology is employed in every step of the manufacturing process.

Features of Eibach coilover springs include:

* Ultra-lightweight for reduced unsprung mass
* Maximum deflection, in combination with smallest block heights
* Exceptional block resistance and durability
* Precision parallel and square end configurations under unloaded and loaded conditions
* Lowest side loads with load center ideally located relative to spring axis
* Precision tolerances--the tightest in the industry
* Highest linearity and rate consistency
* Each spring individually tested and rated

More Information
SKU 1000.188.0090
General Specification

Coilover Spring Inside Diameter (in): 1.880 in.

Coilover Spring Inside Diameter (mm): 47.75mm

Coilover Spring Length (in): 10.000 in.

Coilover Spring Length (mm): 254.00mm

Progressive Rate Spring: No

Coilover Spring Rate (lbs/in): 90 lbs./in.

Spring Finish: Red powdercoated

Quantity: Sold individually.

Notes: Block height: 3.000 inch, Load at block height: 630 pounds, travel is 7.000 inch.                              

Write Your Own Review
You're reviewing:Eibach ERS 10.00 in. Length x 1.88 in. ID Coil-Over Spring